Atncorp Firmware Install The Batteries
Atncorp Firmware Download The Latest

When the IR illuminator is switched on you can see the green LED light on the back side of IR850.

If any accessories are missing do not hesitate to contact ATNs Customer Service at infoatncorp.com or 1-800-910-2862.

Ensure that all optical surfaces are clean and ready for use.

Use only 1.5 V batteries.

Make sure that the X-Sight HD is turned OFF before inserting the card into the slot.

Do not force the card into the slot as it may damage both the camera and the microSD card.

To remove the microSD card from the slot, push it in the same thin object.

When it pops up a few millimeters, it can pull with your fingers or tweezers.

Atncorp Firmware Download The Latest

Once you register you will be able to download the latest firmware file.

You will also receive email announcements once a new firmware becomes available.

In the event of a power failure during an update the X-Sight may crash corrupting its system files and will need to be sent back to the ATN factory for service.

When you first turn the device on after program software updating Wi-Fi Motion Sensing Platform configuration takes place.

To turn OFF your device please press and hold the POWER button you will see device shutting down with a count down, please continue to hold the POWER button throughout the entire cycle.

When turning the unit OFF you need to press and hold it for 3 seconds; you will see device shutting down with a count down on the screen.

Its done to make sure that you do not turn off the device accidentally by tapping the wrong key.

Look through the eyepiece while focusing on the reticle on the screen.

By rotating the Diopter Adjustment you will achieve optimal sharpness for your vision.

To change the position of the Rail With Fixing Projection follow the steps mentioned below.

The IR light greatly enhances the performance of your device, while remaining almost totally invisible to the naked eye.

If the visibility is low, you may use the ATN IR850 to improve the visibility.

Still, you should remember that the IR illuminator is just a source of infrared light that enhances the visibility of your device depending on the setting you select on the illuminator.

Atncorp Firmware Install The Batteries

To install the batteries, unscrew the cap of the battery housing and insert batteries following the polarity arrows marked on the housing.

To switch the IR illuminator onoff press and buttons simultaneously.